Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateElite Gate Installation in West Palm Beach: What to Know First
Elite gate installation in West Palm Beach typically runs between $2,800 and $9,500 depending on whether you’re replacing an operator on an existing gate or building a full driveway gate system from scratch. As an independent Elite service provider, we install and service the full range of Elite gate operators, and most replacement jobs are completed same-day once parts are on hand. You’ll get a written price before any work starts, and our 365-Day Done Right Promise covers every installation we do. If you own an Elite gate that needs attention, call (728) 203-0817 and we’ll walk you through what’s happening.
This page is for West Palm Beach homeowners with an Elite gate that won’t open, won’t close, or needs a full replacement. We’ll cover the specific ways Elite equipment behaves in our coastal climate, what a proper installation looks like, and what you should expect to pay.
How Elite Products Fail – and How We Fix Them
Elite gate operators are common across Palm Beach County, particularly the Elite SL-3000 sliding gate operators and Elite CSW200 swing gate models. Here’s what we see on service calls, and how we approach it.
- Elite SL-3000 limit switch drift. The mechanical limit switches on these sliding gate operators can slip by a half-inch or more over time, causing the gate to stop short or overrun the track. The symptom owners describe is a gate that “slams” at the end of travel or leaves a gap. We recalibrate the limits and set the slowdown points properly. If the switch assembly is worn, we replace it with the Elite part, not a generic substitute.
- Elite CSW200 capacitor failure in humid months. West Palm Beach humidity and salt air work through the capacitor seals on swing gate operators faster than the manufacturer’s average lifespan would suggest. A gate that hums but doesn’t move after a summer of daily use is usually the capacitor. We stock replacements for the CSW200 and test both start and run capacitors before quoting anything.
- Photo-eye misalignment on Elite Photocell kits. The sun angle here means afternoon glare can blind the photo-eye sensors if they’re not shielded properly. Elite’s factory kits don’t include sun shields, so we add them during installation and angle the sensors slightly downward to prevent false obstruction signals.
- Gearbox oil weep on older Elite operators. On Elite units that are seven or eight years old, we often find a small oil weep at the gearbox output shaft seal. The gate still runs but drips onto the concrete pad. Replacing the seal is straightforward, but we check the gear train for wear while we’re in there. On some units the gear itself is scored from running dry, and that changes the repair conversation from a seal to a rebuild.
- Elite SL-3000 board failure after power surges. South Florida thunderstorms and the resulting power flickers take out control boards on a regular basis. We install a surge suppressor on every Elite operator we service or install, because the OEM board isn’t shielded against local grid conditions. It’s a small addition that saves a lot of repeat service calls.
Styles & brands we work with
Our Elite Gate Installation Process
Every Elite job we do in West Palm Beach follows the same sequence. Here’s what to expect when you call us.
- 1
Call and diagnosis. You reach a live person, any hour. We ask what the gate is doing and what it stopped doing. Cody Beckman has a phrase he uses on nearly every call: “Tell me what it’s doing and what it stopped doing – that’s usually enough to get started.”
- 2
On-site inspection and written quote. We arrive in a marked vehicle, introduce ourselves, and ask before touching anything. We test the operator, check the gate hardware, and give you a written price before any work begins.
- 3
Parts decision. If the job needs parts, we tell you exactly what’s going in. We use Elite OEM parts when they’re the right choice, and we’ll tell you when a quality aftermarket part makes better sense for your situation. No decision is made without your sign-off.
- 4
Installation. We lay drop cloths inside your garage or any interior path we walk, and shoe covers go on before we step inside. The replacement operator gets mounted, wired, and calibrated to Elite’s travel specs, and we add the surge suppressor and sun shields as standard practice.
- 5
Testing and cycling. We open and close the gate at least a dozen times, checking speed, force settings, and obstacle detection. We load-test the gate by hand to confirm the operator isn’t fighting the weight.
- 6
Cleanup photo and walkthrough. Before we leave, we photograph the work area after cleanup and show it to you. Then we walk you through what we did, what the new settings do, and answer any questions about daily operation.
See the difference
Before
After
Before
After
Before
AfterWhat Elite Gate Installation Costs in West Palm Beach
Elite gate installation pricing in West Palm Beach breaks down across a few common scenarios. These ranges reflect what we’ve charged for similar jobs in the area.
| Job | Typical Range |
|---|---|
| Elite SL-3000 operator replacement (existing gate) | $1,200 – $2,400 |
| Elite CSW200 swing operator replacement (single gate) | $1,400 – $2,800 |
| Full double swing gate with Elite operators, posts, and hardware | $5,500 – $9,500 |
| Sliding driveway gate with Elite operator, track, and install | $4,800 – $8,200 |
| Pedestrian gate with Elite keypad and electric strike | $1,800 – $3,200 |
What moves the price: gate size and weight, whether we’re pouring concrete for new posts, the length of any power run from the house, and whether you want accessories like keypads, vehicle loop detectors, or battery backup. Every quote is written and agreed before work starts. Call (728) 203-0817 for a free estimate on your Elite installation.
Why West Palm Beach Homeowners Call Latch and Post Gate Repair West Palm Beach for Elite Work
We’re a Cedarwell-family gate specialist, not a general contractor. We work on gates all day, every day, and Elite is one of the brands we know best. When the Elite operator in your driveway is acting up, we don’t guess. Our technicians are background-checked and uniformed, and they work to the Cedarwell C.A.R.E. values: clean up like it’s our own home, ask before we move or touch anything, respect the family’s time and quiet hours, and explain the price before the work.
We also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, which matters when a West Palm Beach home has more than one gate brand or a mix of operators on the property. One call covers it. And if the repair isn’t right, our 365-Day Done Right Promise means we make it right. No argument.
FAQs
We do both. Full Elite gate installation in West Palm Beach covers the gate itself, the operator, posts, hinges, track for sliding gates, and any keypads or access controls you want. We’re an independent Elite service provider, which means we’re not tied to the manufacturer’s pricing or parts delays. Call (728) 203-0817 and we’ll give you a written estimate after measuring your site.
Most Elite operator replacements on an existing gate are done in one visit, usually three to five hours on site. Full driveway gate installations, where we’re setting posts and running power, typically take one to two days depending on the concrete work. We’ll tell you the timeline in writing before we start, and the price won’t change without your approval. Call (728) 203-0817 to schedule.
Elite’s warranty generally covers manufacturing defects, but damage from improper installation isn’t covered. We’ve repaired gates where a DIY install caused the operator to fight the gate’s momentum, which burns out the limit assembly over time. The installation we do is set to Elite’s torque and travel specifications, and our 365-Day Done Right Promise covers the workmanship.
When the OEM part is the right call, yes. But we’ll tell you honestly when a quality aftermarket part will last just as long for less money. A good example is the surge suppressor we add to every Elite install: it’s not an Elite part, but it protects the Elite control board from the voltage spikes we get during West Palm Beach storm season. You’ll know exactly what’s going in and why, in writing.
Yes. We remove the old operator and hardware, inspect the gate itself for rust or sag, and tell you if the existing gate is worth keeping or if you’re better off replacing it at the same time. We’ll measure everything, give you a written price for the Elite installation, and you’ll have the final say before any work begins. Call (728) 203-0817 for a free estimate.
Written by Cody Beckman, Owner, Latch and Post Gate Repair West Palm Beach at Latch and Post Gate Repair West Palm Beach, serving West Palm Beach and nearby areas.