Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateDoorKing Gate Installation in West Palm Beach: What to Know First
We install and service DoorKing gate systems throughout West Palm Beach as an independent DoorKing service provider, and most installations take one full day once the equipment is on site. The honest price posture is this: a basic single swing gate with a DoorKing operator typically runs between $2,800 and $5,400 installed, and you’ll see the exact number in writing before we touch anything. If you own a DoorKing unit that’s already here and you need it installed, wired, or brought back to life, call (728) 203-0817 and tell us what you’re working with.
This page is for West Palm Beach homeowners who already have a DoorKing operator, or are about to order one, and want a straight answer on installation, cost, and what goes wrong in this climate. If you’re still deciding between brands, we service LiftMaster, Mighty Mule, and Ghost Controls too, and we’ll tell you honestly where each one fits a South Florida driveway.
How DoorKing Products Fail – and How We Fix Them
DoorKing builds solid equipment, but no gate operator survives the West Palm Beach salt air and afternoon thunderstorms without some care. Here’s what we actually see on service calls and new installations:
- DoorKing 9150 slide gate: limit switch drift. The 9150 is common on longer driveways in neighborhoods like Ibis and Bayhill Estates, and its magnetic limit switches slowly lose position after hundreds of cycles. The gate stops two inches short of fully closed, or over-travels and grinds. Our fix is to reset the limits, clean the switch contacts, and adjust the gate travel so the operator stops doing work it shouldn’t. On a new install, we set travel limits slightly conservatively so the drift takes years to show up.
- DoorKing 6050/6100 swing gate: hinge sag on double gates. Double swing gates put all their weight on the hinge side, and in South Florida’s sandy soil, posts lean faster than owners expect. When a 6100 operator strains against a sagging leaf, the motor works harder and the circuit board heats up. Before installing a new operator on an existing double gate, we check leaf weight and post plumb, and we’ll tell you if new hinges or post reinforcement need to happen first. Installing a fresh operator on a sagging gate is how you burn out a board in eighteen months.
- Aftermarket loop detectors instead of OEM DoorKing loops. DoorKing operators ship with a plug-in loop detector that’s decent but not exceptional. When it fails, some handymen swap in a cheap aftermarket detector that doesn’t communicate reliably with the 9150 or 6500 control board. The gate pauses mid-cycle or ignores the exit loop entirely. We carry the OEM DoorKing loop detector and a quality aftermarket alternative we’ve tested, and we’ll tell you the price difference before ordering either one.
- Solar-powered DoorKing 6050 setups in shaded lots. West Palm Beach has plenty of sun, but plenty of homeowners also have mature ficus and oak canopies over their driveway. A DoorKing 6050 on solar with partial shade will undercharge, and the battery dies during a rainy week. Our install includes a real assessment of sunlight hours, and we’ll recommend either a larger panel, a second battery, or a hardwired power run if the numbers don’t work. We don’t install a solar setup we know will fail.
- Water intrusion in the 1601 telephone entry keypad. The DoorKing 1601 keypad is a workhorse, but its gasket degrades in high humidity and UV exposure. Condensation builds inside, key presses stop registering, and callers can’t reach the house. During installation, we seal the gasket with marine-grade silicone and mount the keypad with the sun in mind. It’s a fifteen-minute step most installers skip, and it’s the difference between a keypad that lasts five years and one that fails in two.
Styles & brands we work with
Our DoorKing Gate Installation Process
Here’s how a typical DoorKing installation goes at a West Palm Beach home, from your first call to the last test cycle:
- 1
You call (728) 203-0817. A live person answers, day or night. Tell us what you have and what’s wrong. Cody’s habit is the same: tell me what it’s doing and what it stopped doing, that’s usually enough to get started.
- 2
We visit and measure. We check gate weight, post condition, hinge alignment, power access, and sunlight. Before we leave, you get a written price for the full job. No pressure, no “today only” talk.
- 3
Parts decision. We tell you which parts need to be OEM DoorKing (control boards, loop detectors, safety edges) and where a quality aftermarket part saves you money without cutting corners. You approve the list before we order.
- 4
Installation day. Crew arrives in uniform, lays drop cloths where we walk inside, and puts on shoe covers before stepping through the door. We handle the operator mounting, wiring, keypad programming, loop detector tuning, and safety edge testing.
- 5
Full test cycle. We run the gate through open, close, obstacle detection, and manual release. If the safety edges don’t reverse the gate in both directions, we don’t leave.
- 6
Cleanup and walkthrough. We clean the work area, show you what we installed, explain the remote programming, and leave you with that cleanup photo in hand. Every installation carries the 365-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat DoorKing Gate Installation Costs in West Palm Beach
Here’s what we tell West Palm Beach homeowners, because you should know the range before we ever show up:
- Basic single swing gate with DoorKing 6050 operator: $2,800 to $4,200 installed, depending on gate size and power access.
- Double swing gate with DoorKing 6100 and two leaf hinges reinforced: $4,500 to $6,800 installed.
- Sliding driveway gate with DoorKing 9150 and steel track: $4,800 to $7,500 installed, more if the existing track needs replacement.
- Labor-only installation of a DoorKing operator you already own: $850 to $1,600, assuming the gate and electrical are in serviceable condition.
- DoorKing 1601 keypad supplied and installed: $550 to $900.
What moves the price: gate weight, whether concrete work is needed, whether we’re pulling a new power run, and whether the existing posts can be saved. You’ll see the exact number in writing before any work starts, and that written quote is what you pay. Call (728) 203-0817 for a free estimate.
Why West Palm Beach Homeowners Call Latch and Post Gate Repair West Palm Beach for DoorKing Work
We’ve been at this since 2009 as part of the Cedarwell family of independent gate specialists, and we focus on gates the way a good mechanic focuses on one make of car. Our techs know DoorKing’s quirks, from the 9150’s limit switches to the 1601’s gasket, and they’re background-checked, uniformed, and trained to work under the Cedarwell C.A.R.E. values: clean up like it’s our own home, ask before we move anything, respect your time, and explain the price before the work.
If a DoorKing part fails within the first year, the 365-Day Done Right Promise means we come back and make it right, no argument and no fine print. And if you call at 2 a.m. because the gate won’t open, a live person answers. That’s not a call center, it’s one of us. We also service LiftMaster, Mighty Mule, and Ghost Controls, so we’re not going to push you toward a DoorKing part if one of those solves your problem better.
FAQs
We are an independent DoorKing service provider, not a DoorKing authorized dealer, so we don’t file warranty claims on their behalf. What we do is diagnose the failure and tell you honestly whether the part should be covered under DoorKing’s manufacturer warranty. If it is, we’ll point you to the right door. If it isn’t, we’ll give you a written price for the fix before touching anything.
Yes. We install customer-supplied DoorKing equipment every month. We’ll inspect it for missing parts and shipping damage before we start, and we’ll tell you if we see something we wouldn’t mount on our own gate. The labor-only rate runs $850 to $1,600 depending on the setup, and you’ll see that number in writing first.
For a standard single or double gate installation with equipment in stock, we’re usually on the schedule within three to seven business days. If your DoorKing operator needs a part we don’t carry on the truck, West Palm Beach is close enough to regional suppliers that we typically have it in hand within forty-eight hours. Call (728) 203-0817 and we’ll give you a real date, not a window.
If your DoorKing operator is under twelve years old and the failure is a limit switch, loop detector, or keypad, repair is almost always the right call. If the control board has failed twice, the motor is drawing high amps, or the unit is over fifteen years old and burning through parts, we’ll tell you that too. We don’t replace what we can honestly repair, and we’d rather lose a sale than sell you an operator you don’t need.
Yes. Every DoorKing installation we do includes the electrical work, the safety edges, the loop detector setup, and the keypad programming. Obstacle detection is non-negotiable on our installs, because a gate that reverses when a kid or a dog walks through is the whole point of a safe driveway. We won’t leave a gate operating without working safety edges, no matter how eager you are to close the job.
Written by Cody Beckman, Owner, Latch and Post Gate Repair West Palm Beach at Latch and Post Gate Repair West Palm Beach, serving West Palm Beach and nearby areas.